All, I have a Cutler Hammer D50 Devicenet I/O module model DN50SAA14. Does this module have any logic capabilites or is it just an I/O block? It says "D50 Programmable Controller" on the front, but that may be just saying it's part of that series. I found a one page PDF online about these modules. It's a bit ambiguous as to what these blocks are capable of. It does say that you can use Netsolver (relabled Steeplechase) or Netview to configure it. However, no one here seems to know where the software is. I hate to throw it away because it looks like it might be handy, but it's pretty much an anchor if I can't find software for it. I've been through the previous CH discussions, but haven't found any info/software specific to these modules. Any help is appreciated. Thanks, Aaron
