Hello all, I have a control net network setup with 3 panelviews on it. i did not setup this network but have been charged with the task of maintaining it :) The nodes are addressed 12, 13, and 14. Everytime there is a power failure in the mill, node 13 loses communication and reloads the program as node 14 which causes it not to work. How do i ensure node 13 allways stays node 13? During the last power failure node 12 PV would not boot up with an error code 40 so I replaced the PV. node 12 now shows a mismatch in rsnetworx. how can i resolve htis? I hope this is enough information to understand whats going on. thanks