vasekd
MrPLC Member-
Content count
59 -
Joined
-
Last visited
Posts posted by vasekd
-
-
-
The problem is probably caused by the language version of windows. Use 1,0 instead of 1.0
-
There is no need to immediately change a working thing for a new one
-
I have the same message from the Czech OMRON office. We have about 300 NS panels in our plant. Fortunately, the panels are trouble-free except for mechanical damage. The next replacement will be the NB series. But the program needs to be written completely again.
-
Date and time uses internal memory LW10000 - LW10005. Use number input function to these addresses.
1 person likes this -
Profibus-dp parameters cannot be uploaded from PLC.
-
programmer v 9.76 - basic units - fourth
-
For PLC all is set by Dip switch
-
Try to use default serial setting - PLC DIP switch 5 ON.
The default settings for the RS-232C port are: host link mode, 1 start bit, 7
data bits, even parity, 2 stop bits, and a baud rate of 9,600 bps.Im using OMRON interface USB - serial CS1W-CIF31. But the price
-
-
You need to use original omron serial cable (or make it) from converter to PLC due to non standart pinout (see chelton message)
1 person likes this -
-
You have to buy new CF card (max 1 GB) and use it without any formating (never format this card).
1 person likes this -
Is it really cx-programmer version 9.5?
-
-
In the machine is array with size 100 (ARRAY [1..100]]. Can I simply change it to 200 without data loss?
-
Hi, cpm1a-40cdr-a-v1 has relay outputs. Contact connects corresponding output with COM.
-
My v 1.24 is working too.
-
Oh, that may be it. I will have to contact the supplier. Many thanks for clarifying.
-
Thanks for your reply.
Original PLC is working without problems. I wanted to make a backup. There are no problems to make upload from other machines (about 10). By Synchronize (from PLC) I see message: emty rungs. Maybe some protection from supplier?
-
-
PLC? memory card? switches setting?
-
Hallo,
105 isn't value it is CIO address. It will be #105 (Hexa) or &105 (Decimal).
-
Thank you for the explanation. It made me learn to use IR, DR. I think it will be a good solution for my program.
Sysmac Studio feature
in NJ Series / Sysmac Studio
Posted · Edited by vasekd
Thanks a lot