Juan
MrPLC Member-
Content count
3 -
Joined
-
Last visited
Posts posted by Juan
-
-
Thanks for your reply. Yes I was connected serially before. I finally got it choosing "Ethernet" in the "Network Type" selection. I still would like to know how to connect them in FinsGateway mode. The IP address of the PLC is set with number swithches in the back of the Ethernet unit. Then, the node number switch is set making sure it matches the last octet of the IP address... I've noticed however that the Ethernet connection works a little less stably than the serial connection as it hangs for short times once in a while. The communications get lost and restablishes some times Any suggestion on how to improve this condition? Any guidance on how to set up the FinsGateway mode? Thanks to all -
Hi there, I need to set up an Ethernet connection between a PC running CX-Programmer V3.0, CX-Supervisor V1.1 and a PLC type CS1G-CPU42H. At the PLC side I'm using a CS1W-ETN01 Ethernet card along with a 10Base-T conversion adapter. At the point where I am, I'm only able to ping the unit from the PC and get the reply, however I cannot get it connected with the CX-Programmer or the CX-Supervisor. I've tried different things but without any success. Could anybocy please assist me on this with a step by step instruction? What I'm pursuing at the end is to run the CX-Supervisor SCADA application in Ethernet mode at Ethernet speed, and if possible, monitor and program the PLC from the CX-Programmer, not necessarily simultaneously. I appreciate your help and thank you in advance.
CX Supervisor with SQL Server
in CX-Supervisor
Posted