philbee

Thanks for the replies guys, i took both your advice and went through my driver setup and it was ok and then connected the terminal directly to the plc upstairs and it worked perfect, so i ran new cat5 cables to downstairs and so far everything is Also, while searching through your forum i found where sparky had mentioned the functions for the small pot on the back of the screen, we had a defunct screen here where the touch was about half an inch too low and therefore no use to us, so i used the calibrate touch function and hey presto, good as new again HUGE thanks for the help guys, very grateful

Hi, My first post here guys so go easy on me the crew at work decided to wash the e910 hmi the other night with about 10,000 litres of water and ruined it, weve got a replacement and i have the original program on disc, im using e-designer ver 6.10 to download to the screen but the prob is when we power up the screen button are very slow to respond and comms error is flashing on top left corner. the program was designed for firmware version 6.0 but the screen carries firmware version 6.1, could this effect it? i tried to convert the program to suit firmware 6.1 using e-designer but i get the warning message that some objects are not suitable for 6.1 and will be deleted. Ive been trying to locate the firmware version 6.0 for the screen on the net but i cant find anywhere, im really stumped, can someone please. many thanks in advance