imounenben

i don't know the settings for the hardware, but in the veraspro soft the default setting are the same you listed above , however i tried with those setting but i couldn't get it work. the length is less then 2 meter. the OK led is on and the power led is on too, the 15 pin connector is in the power module thanks for your help

i've tried to implement the cable following data set in this link http://www.plcs.net/dcforum/DCForumID5/1053.html but i didn't get it wor , could any one list for me the communication setting in the versa pro for snp- t1 ,snp-t2,and snp-t4,snp-t5 and also the baud rate used and parity . thanks

thanks steve, i'm running versa pro and IO remote manager . i'm far away to get the horner he693snp232a snp to rs232 adapter, so i want to ensure that implementing that direct cable mentioned in that forum can solve me the problem? GE Fanuc 90-30 Direct Cable 9 pin-F 15 pin-M Rd 2 --------------------------- 12 SD+(B) Td 3 --------------------------- 10 RD+(B') Sig.Gnd. 5 --------------------------- 7 SG RTS 7 ---| --- JUMPER --- |--- 6 RTS+(B) CTS 8 ---| |--- 15 CTS+(B') DTR 4 ---| |--- 8 CTS-(A') DSR 6 ---| |--- 14 RTS-(A) (A)= - (B)= + (A'),(B')= INPUT (A),(B)= OUTPUT thanks for you r time and help

please could any body help on this, i want to know what should i use to get communication fro DB15 GE fanuc serie90-30to my DB9 serial communication port. what's the communication protocol used by GE fanuc serie90-30,?

hello, what should i use to connect my serial port DB9 laptop connector to DB15 GE fanuc serie 90-30, what's the typ of protocol that the GE 90-30uses ? thanks for your help