1292dem

Not to familiar with floating point math, never had to use it...I probably should have been more specific what I'm after as far as the code goes. Were not using a flow totalizer to capture the mls, just using a beaker to dispense into, valve opens at a constant pressure/flowrate (not measured & locked out) and we count how much time it took to fill the beaker, enter how much mls were dispended into the beaker on the screen then the math is done to determine how much was dispensed over time in . Any ideas on how to make this work???

Hello Folks, Been an on/off forum reader for some time now....this is my first post. My apologies if I post in the wrong area... I'm using a CJ1M/CPU23 platform with CX-One software. Here is my challenge: to capture H20 in ml (xxxx) dispensed over time in secs (xxx.x) and displaying this result as xxx.x ml/sec on an NS8 screen. I can get it to work with out the the decimal but after that the code breaks. I have tried several different instructions and can't seem to get the reults I need. The math is fairly simple H20/time = ml/sec. Not looking for a handout just trying to understand where my mistake(s) are so I can further learn from them. I will be truley greatful for any help provided!!! Thanks again :)