colinthebassist

Checked the battery and the inside of the CPU. Nothing is leaking and all the boards look good. I have tried both the peripheral port and rs232 port at 2400 baud. I may try and make an omron specific rs232 cable tomorrow to see if I can connect that way as the standard rs232 cable doesn't work. Also when setting connection to 2400baud, 7E2 on the peripheral port I get lots of activity from the com1 LED on the CPU, but still no connection. Network and node both default to 0 and I cannot change that setting(grayed out).

Still no luck with those settings PMCR. I have CX-one v1.11, and CX-Programmer is v6.11. The powersupply on my unit is a PA203, and only has one terminal for 120VAC hot. Could it be that the peripheral port has been configured for something no standard? I could make a rs232 cable and try connecting to the unit that way instead of using my CQM1-CIF02 cable. Also currently there is no lights illuminated on my cpu, although the com1 light does blink on occasion when attempting to connect. Dip switch settings are as follows: Memory Protect: on M/C Auto Read: off Message English: on Default instruction set: on RS232 fixed setting: on AR0712: off

Hi all. I have a CQM1 unit with a CPU 41 that I am trying to connect to. I've bought the CQM1-CIF02 cable to connect up with it. I've set switch 5 to ON to set comms back to standard. I've set my network settings to sysmac-way, 9600, 7E2. When attempting to connect with the network config utility the activity LED does blink maybe 5-10 times but the connection always fails. Auto online also fails 100% of the time. Any help to get this working is much appreciated!