Jay Anthony
MrPLC Admin-
Content count
3651 -
Joined
-
Last visited
Content Type
Profiles
Forums
Downloads
Calendar
Everything posted by Jay Anthony
-
What PLC? What cam controller?
-
The takeaway from above:
-
This is your example.
-
Please post your CJ1M program. Several of us can take a look at it.
-
What is MagicK packet?
-
What instruction to be used in controlling variable frequency drive(VFD)
Jay Anthony replied to Kernel's topic in CX-Programmer
Does the vfd support ethernet?? -
FUSE Protection for Sinking Input and Ouputs
Jay Anthony replied to BITS N BYTES's topic in General Topics - The Lounge
consulting-resources: Please refrain from posting to topics that are more than one year old. -
No problem communicating CJ1M with upgrade to CX Programmer 9.6
-
Look at ANDW and MOVD.
-
The advantage to Binary mode is being able to use a much larger setpoint (#FFFF=65535) over (#9999=9999),
- 1 reply
-
1
-
Labels can be added to the table. See ppt and lab below. 06b - Tools - Repeat and Table 111304.ppt 06b Repeat and Table Functions 1061705.doc
-
Use Table
-
Sounds like the bus connectors on that AD card are flakey.
-
37 loops to commission? You might still be there. It's a great rodeo.
-
Good luck pardner. Sounds like you ought to pack it up and head to the hotel.
-
Btw: Going to the rodeo next month?
-
Stupid question: Do you have the end cover terminators in place on both racks? Also the IC101 should be placed next to the CPU. The II101 should be placed next to the power supply.
-
Look for bent pins on the bus connectors between each module.
-
Had another guy in Great Britain have the same issue and he had a bad IC101.
-
Should work. Do you have the jumper on the Expansion rack power supply for 120VAC? Sorry. My bad, There is no jumper.
-
IC101 belongs on Main Rack. II101 belongs on Expansion Rack.
-
Custom Made NT31-V2 Cable & Timeout Error
Jay Anthony replied to Dark Frost's topic in Other Omron Software
universal-cable-for-omron-9-pin-port -
When the conditions are true before the @MOV, the @MOV is executed for one PLC scan only. The conditions must be false and then true again for the @MOV to happen again. Above is not the right answer to dalt_Hub's question. See Mendon Systems below.
-
Totally missed where he said that the @ symbol was used. You are right Dick.