Dear Lenze experts,
Not sure if reviving a topic that it is more than 1 year old is a good idea, but I'll try.
I have a similar issue that the OP described. I have a 933x-ETV907 Servo PLC drive that I need to replace, but it has a PLC program inside it, and I can't
upload it. The information about EMZ2221IB device is very helpful! Even though it's expensive and hard to get, we are looking for a ways to buy it urgently.
But I wonder if there is a GD Loader software (or a sub-function of the GDC) ? According to some older Lenze's GDC software manual (see attached screenshot), there was a program/function for transferring PLC program to (and maybe from?) the drive. Does anyone have any experience in this? This GD Loader software seems hard to get these days as well. Or if you happen to know any replacement for that GD Loader software that could do the same or better job, please kindly mention it here.
Thank you for any feedback you may provide.
S4gia
