ghitisor

MrPLC Member
 View profile  See their activity

  • Content count

    7

  • Joined

  • Last visited

Posts posted by ghitisor

  1. Posted

    On 10/30/2006 at 1:05 PM, tashinz said:

    in cx-one 2.0e there is NT-Support Tool 4.8 and Dos version 2.33. I think it's in the disk3. you have to manualy install it since you can not approach it through the install menus of the cx-one. regards

    Hello
    I have a problem with a hmi omron NT600m-DT211.
    I have to copy the program and do not know what software to use.
    I have NT-series soft but the starboard does not appear in the list.
    What to do?

  4. Posted

    18 hours ago, IO_Rack said:

    For starters, here is the manual. This is a very, very old HMI. The most recent version of NTST (NT Support Tool) is 4.8 but I don't know that it will support the 600M. Check the downloads section here at MrPLC. There are some older versions there and I don't know which version you will require. There was an older DOS version called NTSS.

    There are some members here that may remember. Hopefully they'll chime in.

    EDIT:  Someone has a better memory than me! (See Garry's reply below)

     

  5. Posted

    6 hours ago, IO_Rack said:

    For starters, here is the manual. This is a very, very old HMI. The most recent version of NTST (NT Support Tool) is 4.8 but I don't know that it will support the 600M. Check the downloads section here at MrPLC. There are some older versions there and I don't know which version you will require. There was an older DOS version called NTSS.

    There are some members here that may remember. Hopefully they'll chime in.

    EDIT:  Someone has a better memory than me! (See Garry's reply below) 

    Thanks for the answer, I know it is very old but I need the program from it to replace the equipment with a new version.
meanwhile, the equipment has to work.
I have 4 spare dispay but I have to transfer the program from it.
For any additional information please do not hesitate to contact us.

  6. Posted

    6 hours ago, IO_Rack said:

    For starters, here is the manual. This is a very, very old HMI. The most recent version of NTST (NT Support Tool) is 4.8 but I don't know that it will support the 600M. Check the downloads section here at MrPLC. There are some older versions there and I don't know which version you will require. There was an older DOS version called NTSS.

    There are some members here that may remember. Hopefully they'll chime in.

    EDIT:  Someone has a better memory than me! (See Garry's reply below) 

    Thanks for the answer, I know it is very old but I need the program from it to replace the equipment with a new version.
meanwhile, the equipment has to work.
I have 4 spare dispay but I have to satranser the program from it.
For any additional information please do not hesitate to contact us.

  7. Posted

      
    Hello!
I have a problem with older equipment and I have to copy the data from it
To connect to a hmi omron modelNT600M-DT211 what type of software should I use and if possible the connection scheme between hmi and laptop.
Thank you!