Posted 2 Jun 2015 Dear All I have some problem with CC Link IE module QJ71QF11-T2 Link to NZ2GF2B1-16D and NZ2GF2B1-16T the problem is I can not read/write to remote I/O at X1000/Y1100. please help me Thank in advance Thanya 1 person likes this Share this post Link to post Share on other sites
Posted 3 Jun 2015 (edited) You have to write code to initialize the card. I can't remember what bits but there is a bit in the RWr/RWw that needs to turn on to enable the card and then another one of those bits will turn for card ready. I can't find it in the manual but found it in a program. bit 8 of the first RWr register needs to be turned on after bit 8 of the first RWw register turns on. So you will need to add the RWr/RWw registers to your refresh parameters. Edited 3 Jun 2015 by Delbert Share this post Link to post Share on other sites