Mantas Rukuiža

How to set MX2 so it starts ("RUN") automatically after power on

6 posts in this topic

Hi, i configured MX2 Inverter, using analog buttons to switch it on or off, but on CX-Drive i can't find the option to autostart after it is powered on. I need to press "run" for it to start.

I'm sure it is possible, any ideas / guidance much appreciated.

Share this post


Link to post
Share on other sites

Look at parameters b001.

Also C001, for Start options, 2 wire or 3 wire.

Share this post


Link to post
Share on other sites

Posted (edited)

No luck so far..

It's 3-phase setup.

I think, basically what i need is  inverter to resume "RUN" after power off.

Edited by Mantas Rukuiža

Share this post


Link to post
Share on other sites

Wire the run signal through the 'ready ' output relay

Share this post


Link to post
Share on other sites
On 8/21/2019 at 9:23 AM, ParaffinPower said:

Wire the run signal through the 'ready ' output relay

Any chance you could give instructions with ref to the markings of the inverter?

IMG_20190827_074716.jpg

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now