Kiiza

KOYO PLC C0-02DD1-D OUTPUTS

5 posts in this topic

Hello guys, hope you are well.

I have with me KOYO PLC C0-02DD1-D. I have programmed it successfully. However, I do have a challenge with it's digital outputs. I expect a voltage of 24Vdc from the outputs but I am instead getting a voltage of 12Vdc. Even the 12Vdc I measure at the outputs looks fake voltage because whein I use it to energize 12Vdc relays, they don't get energized. I appreciate your help.

Thank you very much.

Share this post


Link to post
Share on other sites

That unit has sinking outputs so chances are it is the way you have it wired.  You should have 24VDC connected to your load (relay) then the minus wire of the relay should go to the output.

To properly test the output, put the red lead of your voltmeter on +24VDC and the black lead on the output.

Share this post


Link to post
Share on other sites

I will try that out. Thank you very much.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now