Sign in to follow this  
Followers 0
bagged2drag

TIA Portal V13 Assign Profinet Device name

2 posts in this topic

Hello,

I have a Siemens S7-300 using Tia Portal V13.   It is connected to an ANYBUS Communicater.   The Anybus configuration became corrupted.  I reset it per a conversation with a vendor.  I need to now reset the device name, as it has been cleared out.  The Siemens sets the device name according the the device properties.  Right now I get a fault that the anybus is not reachable.   Is there a way to reset the device name?

 

Kris

Share this post


Link to post
Share on other sites

bagged2drag.

If you have the MAC-Address you can use the PST Too from Siemens Automation (Primary Set up tool). This is the tool I use to initially configure all nodes on my Profinet networks.

Confirm you have the correct MAC Address before applying an IP Address and node name.

If you have an issue with the AnyBus card- you may need to restore factory defaults before carrying out the method above.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0