CrustyBurger
MrPLC Member-
Content count
4 -
Joined
-
Last visited
Posts posted by CrustyBurger
-
-
Hello,
I have managed to send output to a terminal using a serial channel. I have not been able to send data from the terminal to the Mitsubishi PLC.
I am not using terminating resistors but I have a slow baud rate of 4800. I am just using regular wires (1.5mm square) . I think the hardware is okay as I can see the output from the PLC on the screen.
Attached is the code. I just send from the terminal the character 22 every second,
I hope this is not too incomplete to get some help. The plan I guess later is to interface with LabVIEW probably using Modbus but I need to try to get this working first.
-
After turning off the PLC and back on it is okay now. I am going to have to try to get it working for the digital to analog next. Sos about the earlier post.
-
Mitsubishi FX5U Serial RS485 - non procedural communication
in Mitsubishi
Posted
Hi Gambit,
I need to send information to LabVIEW and back. This might be achievable by digital I/O but I would prefer to do it via serial (RS485) or internet. I am using an fx5 plac and I have downloaded LabVIEW.
I achieved the above using RS485 to USB cable.