Hi,
I have successfully converted F940Got HMI software to GT1000
and since the conn. to the plc was the same 9-pin dsub as on the original HMI
it all worked fine.
Now I have converted F930Got (smaller HMI) to GT1030
but the plc comms connector is different (terminal strip instead of 9-pin dsub)
and I cannot figure out how to wire an adapter between the 9-pin dsub (on original plc to got930 cable)
and the 9-way terminal strip.
A signal pinout of the FX2N round 8-way connector would be a good start
or
is there a ready made connection cable with pinout somewhere on net?
(FX2N-30MR to GT1030)
Lars