Akahige

Are you trying to do this all on HMI or along with a PLC program? If just HMI select the button, open the animation properties tab for said button and execute your expression. I hope this is what you are seeking. Good luck.

The operator manual is located here:   http://www.eschneider.pl/download/04%20Automatyka%20przemyslowa/PLC%20sterowniki/M241_PLC_Modicon-Hardware_Guide_2014ENG.pdf and http://www.filkab.com/files/category_files/file_3079_bg.pdf From this last manual I found the following:  

you might find more information on the PLC from the manuals provided by Schneider: https://www.schneider-electric.com/en/product-range-download/62129-logic-controller---modicon-m241/#tabs-top @saruans

If the fire and gas detection systems has dual wire discrete interface, you should be able to interconnect to safety RIO module. Your question is a bit broad. You might need to be more specific. What are you intending to connect. Does your detection system meet the IEC safety standards.

http://www.xlogic-plc.com/xLogic%20text%20panel(ELC-MD204)%20USER%20MANUAL.pdf Chapter 4.1 of the MD204L HMI manual gives you instructions on connecting to a Mitsubishi FX PLC

Gambit is correct. There is no instruction that will get three random bits in one word to transfer to another. The best would be using the Kn designation to move 4bits (minimum, 32 bits maximum at 4bit increments) at a time.  

How is the HMI connected to the FX unit. Is it a Mitsubishi HMI?

Change the E-net ADP port to 5556. This should fix the routing. F.Y.I. If you had a SFM E-net module that module's port is typically 5551.

Hmmm...  

@Ashes a basic question for you: Have you installed the GS Installer.exe?

@bakkerfrits I used the search engine (after sign in) and this resulted: Unfortunately without signing in the search area is limited:

@bakkerfrits Go to the Mitsubishi website: https://us.mitsubishielectric.com/fa/en   On the upper right hand you will see a Sign In and My Mitsubishi link. in order to go to the My Mitsubishi link sign in (create a user's account, free and no obligation required): Once in the My Mitsubishi link (only available after signing in) you can find these documents two ways. Under the the Knowledge base or placing the product number (the number provided in my previous post) in the search engine in the upper right corner:   Hope this helps.  

Mitsubishi came out with a tech bulletin on this (R72-141-SLSASG-007). It is available on their website but here is the copy I have downloaded:   TB - iQ Works Navigator Exporting GXW2 Project Procedure.pdf