mustaqim90

i do not understand. can u explain more detail about it.

I WANT TO COMPARE CURRENT VALUE TO A PREVIOUS VALUE

hi. i have a problem. im using omron cx-programmer..how to write the program to find maximum and minimum value in ladder diagram using the formula (tn < tn-1) and (tn > tn-1). help me..

hi i have 1 crt1-id16 and 2 crt1-ad04 cards..i already set a different node address in all slave cards.when i try to link all card, the status will show "the slave unit duplicate address is error"..how to solve the node address duplicate??..hmm

hi im newbies. i have cj2m plc need to connect to wonderware intouch scada but I dont know the configuration setting. i try use dasomfinsenet but it error.can cj2m plc communicate with wonderware intouch??..pliz help.. thank you

hi.. i have done build a ladder program with cx-programming and i want snow the result in wonderware intouch software..lets say i want show a value in memory CIO0008. how can i show this value in wonderware?. how to communicate between omron plc and wonderware?

hi.. i want made a counter..i have 4 sensors to detect the box and count it..i use one counter for each sensor and i add all 4 counter. but i cant get correct value.why? why i get the value 18??.. it should be 12 right?

I want to know to write a program into omron plc according to the temperature value. Can u please help me. For example, let say when the temp is 50C.How can i write this program?. i try do the scaling using SCL but i get wrong result..can someone check the program?? i use cj2m-31cpu,cj1w-crm21,crt1-AD04

Hi.. hope anyone can help with my problem.Using CJ2M-CPU31 (setting: node no :1, unit no: 1), CJ1W-CRM21(mode :8, mach no.: 2) and remote terminal CRT1-ID16 (node address : 1). when on the power it keep getting error message that I can't clear. i think problem in hardware and software setting. Any help would be appreciated as I am still learning on the fly.