Posted 6 Jul 2006 Hello Any body can help? I don,t connection ProTool with OP17, have eroor E2044. I have this diagram connectin cables: op17 pc 15-pin 9-pin 10------------------------------7 3-------------------------------2 4-------------------------------3 5-------------------------------8 15------------------------------5 Any body know correct this diagram or not? Share this post Link to post Share on other sites
Posted 6 Jul 2006 Hello Or i need use this diagram for connection? op17 pc 15-pin 9-pin 3----------------------------------3 4----------------------------------2 12--------------------------------5 -7 I -8 -1 I -6 I -4 This cables 6XV1440-2K... What cables correct for connection op17 with P?? Share this post Link to post Share on other sites
Posted 6 Jul 2006 (edited) Hi Kmd, You have the correct cable 6XV1440-2KH32. Don't know what your error message is - cant see that one in the manual (available from the downloads section of this forum). Can you get into download mode ie. ESC + UP CURSOR when turning panel on or alternatively via System Settings/Opmode/Download ? Edited 6 Jul 2006 by gruntstripe Share this post Link to post Share on other sites
Posted 7 Jul 2006 Hello Thank for info about cables. I have 2 panel op17, old panel and new panel, i want upload progran from this panel and download in new panel. In old op17 destroy many button (ESC destroy too). I can not press "ESC" + "up" bighouse "esc" button destroy, can not make "Transfer mode". Connection with new panel correct. What can i do in this situation? Share this post Link to post Share on other sites
Posted 8 Jul 2006 Hi, If you want to transfer the program from one OP17 to another one. it is better to use the Prosave. Good Luck Share this post Link to post Share on other sites
Posted 15 Aug 2006 in creating the program,there are standard menu for transfer mode,,if the programmer configured it in the screen,,a big problem if not included Share this post Link to post Share on other sites