Posted 12 May 2014 1. After saving changes within RSLogix 5000 I am given a warning as follows; RSLogix 5000 project saved successfully. Merging topology to EtherNet/IP project file c:\documents and settings\mm0302\desktop\keyence_4600_0101.eds.enet... Warning: EtherNet/IP project file not found. Go to RSNetWorx tab in Module Properties and click OK to create it. Complete - 0 error(s), 1 warning(s) 2. I am currently hooked up to two Keyence cameras and the other two are not hooked up, but they are set up within RSLogix 5000. Is this the reason for my i/o not responding message in upper left? Thank you for the help Share this post Link to post Share on other sites
Posted 19 Dec 2016 Turn your windows automatic updates off, selectively install them and be ready to roll back to a previous restore point. 1 person likes this Share this post Link to post Share on other sites