Logo Simulator Error

[Davo 0]

Okay. So I have a program with various fault conditions; six inputs, four outputs, two alternating pumps on a basic x-0BA5 Logo. It works fine in the simulator, and almost works fine in the field. Except it gives a fault light (but still runs). The fault light goes out when the "run" signal is jumped out on the motor starter protector of the _idle_ motorstarter. While this should, in fact, cause an alarm (and does on the simulator), it fixes the alarm in the field (and on my desk in a duplicate environment). Are there any known bugs that might relate? For those interested, a screenshot of the program is at http://morelight.org/davo/logoprog.jpg and a copy of the program is at http://morelight.org/davo/logoprog.lsc Thanks for any help! Edited 17 Apr 2008 by Davo

[Davo 0]

So, I re-wrote the program and attached a bunch of lights and switches so I could duplicate the field. This new program behaves in the simulator as it does on the Logo. /shrug