Kabil

MrPLC Member
 View profile  See their activity

  • Content count

    5

  • Joined

  • Last visited

Posts posted by Kabil

  1. Posted

    HI, 

    Intention:

      We have NX701-1700 and NJ 101-1000 plc's and we want to do read/write  service with NX/NJ plc through ethernet IP protocol. 

    Query 1:
        Will you please suggest the command which we can use for read and write job with NX/NJ and the command structure of the same.

    Query 2:

          Will you please share Supported operands and their opcode's for NX701-1700 and NJ 101-1000. Please share the relevant manual document for NX and NJ through ethernetIP protocol.

    Thanks

    Kabil

  2. Posted

    On 4/17/2019 at 8:45 PM, Michael Walsh said:

    You can set up a tag datalink between the two so that they automatically share data back and forth.  Or you can use a CIP Messaging command to only send the data when you want.  

    The EtherNet/IP manual is installed with Sysmac Studio and is found here by default:

    C:\ProgramData\Omron\Sysmac Studio\StartMenu\Sysmac Studio\Manual\NJ_NX Series (you can find it in your start menu).  

    The instructions for sending a message only when needed are:  CIPSend and CIPRead

    However, I would recommend using FINS and the SEND and RCV instructions.  You can find a write up on this process here:

    HI Michael,

       Will you provide the below document.

           C:\ProgramData\Omron\Sysmac Studio\StartMenu\Sysmac Studio\Manual\NJ_NX Series (you can find it in your start menu).  

        Note:

             I have installed the sysmac studio trial version (standard Edition ver 1.20.1). I could not able to find the startmenu.

    Thanks

    Kabil

                      

     

  3. Posted

    HI, 

    Intention:

      We have NX701-1700 and NJ 101-1000 plc's and we want to do read/write  service with NX/NJ plc through ethernet IP protocol. 

    Query 1:
        Will you please suggest the command which we can use for read and write job with NX/NJ and the command structure of the same.

    Query 2:

          Will you please share Supported operands and their opcode's for NX701-1700 and NJ 101-1000. Please share the relevant manual document for NX and NJ through ethernetIP protocol.

    Thanks

    Kabil
        

  5. Posted


    Hi,

     Any one suggest me the holding memory operand and address of CPU State and CPU Type with CJ and CS Series PLCs.

      I could not able to find any documents regarding this topic. Please share any documents regarding this.

      Currently we are using SendRRData command for read / write requests. Shall we use the same command for CPU state and CPU type read / write ??

      Is it any way available to find the holding memory operand and address of CPU State and CPU Type with CX programmer?

      Please share yours valuable inputs.

    Thanks
    Kabil