[retain information in a 3g3mx2 drive]

Hi Folks

 

I have a NB5QTWOOB HMI and a 3G3MX2 drive. I am sending values directly to drive from HMI. We keep the HMI powered but on a stop or estop we dump power to the drive. When we power up the drive it does not retain the values we last inputed, it goes back to default which is 0. Is there any way to have the drive retain last value entered before shutting it down?

 

Thanks

Ron

[CPIE MOV ISSUE]

It finally worked after compiling and downloading 3 times lol

 

Thanks for the assistance

[CPIE MOV ISSUE]

I just added line and reset button and it didn't reset? 

[CPIE MOV ISSUE]

is there a way that I can just reset the counter using a pushbutton on the HMI?

 

Thanks

[CPIE MOV ISSUE]

There is a #12 there now because I was trying other numbers

[CPIE MOV ISSUE]

I am trying to move a #16 into w505 when I push the reset button on my HMI. The Reset button works but the MOV isn't working. So obviously I'm doing something wrong.... This is my first time programming with CX. Please help. See attached

 

Thanks

[CP1L Internal ANALOG INPUT]

Thank you!!!!

[CP1L Internal ANALOG INPUT]

Where do I find the raw value for an internal Analog Input on a CPL1. The analog input has a 2 wire connector.I have a 0-10vdc signal going to it.

 

Thanks

[CX-p.exe system error omron]

When I go to start my CX Programmer it comes up with this error cdmapi32.dll is missing. I have just downloaded the software new on my computer.

 

Thanks

Ron

[CP1L 0-10vdc input programming]

Yes it is the internal analog input. My required set point is at 170Deg F so I'm guessing that I will have to use a temp controller and scale it before PLC input!?

[CP1L 0-10vdc input programming]

13 hours ago, BITS N BYTES said:

Are you using the built-in analog input on the CPU or an analog expansion module?

 

9 hours ago, BobB said:

Try this - it works. http://forums.mrplc.com/index.php?/files/file/996-analog-scaling-function-block/

This looks great can you help me set it up? Looking at what parameters I have above.

Thanks

[CP1L 0-10vdc input programming]

Built In analog

[CP1L 0-10vdc input programming]

12 hours ago, BITS N BYTES said:

Are you using the built-in analog input on the CPU or an analog expansion module?

Yes

[CP1L 0-10vdc input programming]

Hi

I need to know how to program a SCL 194 or how to accomplish the following:

I have a RTD range 32degF to 1400degF coming in to a converter the Input to PLC is 0-10vdc. This is my first time programming with CX Programmer. See below this is how the signal is coming in now? Would like to know the best way of creating a result to use in my HMI.

 

Thanks