GoTech07
MrPLC Member-
Content count
3 -
Joined
-
Last visited
Posts posted by GoTech07
-
-
I am adding a remote device to an existing cc-link network. The master station is an A1SJ61BT11 and the CPU is A2USHCPU-S1. The CC-Link network currently has 20 remote I/O stations and I am adding a remote device. The A1SJ61BT11 has parameters written to its internal memory. In order to add my new remote device, I think I need to only change two parameters: First, I need to change parameter address H1 from 20 to 21 since my device will be the 21st. Second, I need to change station information parameter address H34 from 277 to 4373 to enter it as remote device. I looked at the example in IB(NA)-66721-J(0310)MEE, section 6.3. In the example, they are setting up the parameters for the first time. However, I am only changing two of the parameters. I followed the example except I only entered rungs to change the parameters for H1 and H34. My question: If I run the parameter setting program to only enter parameters for H1 and H34, will it affect the other parameters the original programmer entered? Could they go back to default? Any advice? Thanks in advance -
I would like to combine two existing machines with CC-Link. Each machine has a QJ61BT11N set up as its Master Station. The larger machine has 26 remote I/O and 4 remote devices. The smaller machine has 1 remote device (see the attachment). Each are already programmed and running. The larger machine has HMIs that I would like add screens to in order to control the smaller machine as well. The smaller machine would basically just need to send and receive a handful of signals... start, stop, manual, origin, e-stop, fire specific outputs, etc. What would be the best way(s) or simplest way(s) to connect and communicate between these machines? I am open to any advice and ideas. Thank you Machine_Addition_Via_CCLINK.bmp
Adding A-Series CC-Link Remote Device Parameter Settings
in Mitsubishi
Posted