Grisha
MrPLC Member-
Content count
14 -
Joined
-
Last visited
Posts posted by Grisha
-
-
Hi RussB, Yes i mean RS-232 and 485. with my experience with this device some of them even they new from the package are not working. the main feature i'm looking for that the converter will be able to read more than 1 device per scan(what Lantronix cannot do). any other suggestions will be great and thanks for this ones. Best Regards, Greg. -
Hi tintin, don't have any experience with unitelway but i suggest to you, to check out the communication parameters on PLC(if possible). and configure exactly the same the Magelis panel communication settings. and if you did change the communication cable check it also. Good luck, Best Regards, Greg. -
Hi to all, I interested in all kinds of converters from RS to Ethernet, my current converter is Lantronix and i'm not satisfied 100%. would like to have your opinion and suggestion to other converters. Thanks in advance, Best Regards, Greg. -
Hi smario, I did such project using TCP/IP, i did a counter that after every end of reading promotes it's value and i reset it after i read the last device. Hope its not late and i could help you, Good luck and best regards, Greg. -
Hi acpi, im using pretty old version, 4.4 the issue not the version of the software cause i had already such project with this vijeo version. also i tried to re-install the run time-no succeed. Thanks for the reply, actually i asked for help from our tech support and they will reset the panel with their "special" cable. But im still want understand what happened that suddenly it stopped working. Best Regards, Greg. -
Hi, I facing misunderstood problem, i have been working with a Magelis Touchpanel XTBGT7340. after dowloading the application the panel could not load runtime and popup message "Cannot load runtime" i have tried download other project, or download a new project without any configuration that could make any errors. will be thankful for any help, in technical support says the Vijeo Designer version too low, but i have made same project with the same version on other Panel. Thanks in advance, Best Regards, Greg. -
Hi fou, I'm not familiar with RSview so cant tell you, but i never heared about such thing in Vijeo Designer. Best Regards, Greg. -
Hi fou, yes you can export the variables list into CSV file and edit its parameters. Best Regards, Greg. -
Hi Kiran, Calibration range depends on your process and required temperature to be in controlled and monitored, but it possible within the PT100 ranges. Good luck, Best Regards, Greg. -
You are welcome! -
Hi Lachuu, First of all i not recognized with this devices but the concept is very simple, most of the HMI panels permit to make on a display of a value a calculation, so on from this point you can write down this simple equation with your constants and variables according to your PLC. Good luck, Best Regards, Greg. -
The most sensitive and fast respond Temperature sensor are Thermocouple(any type the PLC supports). That my opinion cause electrical respond faster then resistors. Good luck, Best Regards, Greg. -
Hi dude, It's my new profile(forgot the password) Thanks for your advice, it's not relevant anymore but thanks anyway, and actually i did what have you wrote and it still wrote me the wrong time even if i configured the right time zone, and i couldn't find where can i sync with Magelis time with computers time. Regards Greg.
Data logging
in Other PLCs
Posted