CN2DN Control net to Device net problem

[Aditia Hermanu 0]

Hi,

Any body here experience with CN2DN Controlnet to Device net bridge? I have an ENtek Vibration XM 120 dan Speed Module XM 220 that connected to CN2DN before connected to RSLogix 5000 thru controlnet. My PLC somehow lost that reading from it. I have replaced the XM-120 dan XM 220 card, the CB2DN card and even the back plane, Still the HMI and PLC cannot read . Shall I download RSnetworx configuration file (.xc) to solve this problem ?

 

thanks

[Ken Roach 194]

There were configurations that you needed to load into the XM-120 module, and into the CN2DN (the DeviceNet Scanlist) when you replaced them.    You should have used RSNetworx for DeviceNet software and the backup *.DNT file to load those.

The ControlNet configuration is a separate issue and you should only use RSNetworx for ControlNet if you know how it works and how to use it to schedule your network.