Search the Community

Showing results for tags 'smartstep'.

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Found 1 result

  1. Hi, I'm trying to set up PLC (CJ1G) to control servo motor. I'm using position control unit CJ1W-NC413, servo relay unit XW2B-40J6-2B and smartstep R7D-AP02H servo drive. I'm reading through manuals and feels little overwhelmed with information. Everything is probably there, but it's going to take lot of effort to put it together. Can I found example program somewhere? EDIT: When I put jumper to pin 25 (X axis RUN), motor shaft is locked and motor is holding position, so wiring should be correct. When I try to run a program, I can see that parameters are changing in CX-position, but servo is not moving. Please see attached picture