ChongKY1

Hi, all, I'm having some problem in FTView SE network, regarding alarm bell sound. In the server pc, when the alarm trigger, alarm bell is sound, but in client pc alarm bell no sound. Any setting I need to do or any patch I need to install ? Thanks

Thanks for your reply. I have treid the Configuring the Windows Time service to use an external time source. but it's fail. Do I need to do edit the registry for server and client pc ? thanks

facing some problem in time synchronize. Anyone know how to sync the server time to client pc time ? thank you.

Hi, all, i have setup a redundancy server for Factory talk view se network. there is 4 client in the network. The problem I'm facing is , when I open the trending page in server PC, I can see the history trend. But in client pc, I can only see the real time trending, no historical trending. Anybody facing this problem before ? Thank you.

Hi, PMersault, For windows security setting for the HMI server folder, I had set all the user to have full control allow. Or, do you mean the run time security in the FTView Studio ? Thanks.

Hi, all, I'm having a problem when developing the FTView SE network. When I want to edit a page it give me this error, and i'm not able to open the page for edit. Anyone of you facing the same problem in FTView SE network ?

Thanks. I even thought of putting some glue on it. haha. Can we do a delay for plc to switch to program mode when the operator switch the key to program mode ?

anybody know how to prevent user switch the plc to program mode ? thank you.

I'm not using the SRM card, I am just using control net and with a program to do the redundancy. This is the reason why I need to inhibit the MCM when switch to program mode. DO you have any ideas how to set it in the last scan ? or any others method to inhibit the MCM card when Plc switch to program mode. Tq.

if i didn't inhibit the controlnet, the plc processor which turn to program mode one will still holding my MCM card, the others CPU which is now as Primary cannot take over it. unless the plc which turn to program mode I change back to run mode then only it will release the holding for MCM card. So, when we switch the plc to program mode, which place will always take the last scan ? tq.

i have check my RSlogix v8, EEM is a instruction in SLC 5

hello, all, is there any method to inhibit a module in control logic when the plc is switch to Program Mode ? I have tested the GSV, get the program mode status and then inhibit the module in control logic, but it's sometimes work and sometimes not work (I guess is due to the last scan didn't scan that rung), so anyone know how to inhibit a module when the plc is switch to program mode ? FYI, I'm doing redundancy plc, one plc switch to program mode, another take over as primary, and have to inhibit the control net in the plc which switch to program mode.

Hi, BobLfoot, Thank you. In the first post there, the first picture is the configuration in PV900 and the second picture is configuration for PV1000 which got error one.

Mickey, this is existing running and proven program with PV900 for the Block transfer rung i already posted. just after covert to PV1000 as stated in the first post, it's cannot get the data. tq.

Hi, Mickey, It's 64 Read and 64 write, is this wrong ? currently PLC5 comm with PV900 no problem, but if with PV1000, got problem.