Bill Estey

NT 600 screen

6 posts in this topic

Is there a way to work on a NT 600 screen program using NS Designer/

Share this post


Link to post
Share on other sites
No, NS-Designer / CX-Designer are only for the NS series units. NT Series units will need NTST if it is an NT600S, or if it is an NT600M you will need NTSS. NTSSv233 at MrPLC.com Note: this is a DOS software package. Hope this will help.

Share this post


Link to post
Share on other sites
The software for NT600S is NTST4.7 This software may be exist in CXONE version 2.0 But you can still use the dos version.

Share this post


Link to post
Share on other sites
in cx-one 2.0e there is NT-Support Tool 4.8 and Dos version 2.33. I think it's in the disk3. you have to manualy install it since you can not approach it through the install menus of the cx-one. regards

Share this post


Link to post
Share on other sites
On 10/30/2006 at 1:05 PM, tashinz said:

in cx-one 2.0e there is NT-Support Tool 4.8 and Dos version 2.33. I think it's in the disk3. you have to manualy install it since you can not approach it through the install menus of the cx-one. regards

Hello
I have a problem with a hmi omron NT600m-DT211.
I have to copy the program and do not know what software to use.
I have NT-series soft but the starboard does not appear in the list.
What to do?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now