NS5 AND E5CN COMMUNICATION

[mr_shadow 0]

Hi everybody; I want to ask is it possible to connect E5CN-Q2MT-500 by using E53-CNH03 RS485 Converter to NS5 series HMI from PORTB?. Because the manual "V085-E1-03" says "you can connect Only FLK series temp controllers to NS Series HMI". You can see in the attached file.NS5_E5CN_TEMPCONTROLLER.pdf

[carolina 0]

only you have to check that the e5cn support compowayF protocol, you configure the e5cn in communication mode by compowayF, after you can configurate the portb of the ns5 for temperature control and after in the ns-designer settings > register host, you configurate the e5cn. and you can use the smart active part.

[MPM 1]

Hi, Only FLK units have drivers for communicating with NS Regards, MPM

[sorin.dumitriu@rdslink.ro 4]

Hi! The -FLK termination means that E5_N has factory default the RS485 board inside. You can use without any problems the RS485 option board with E5CN. Do not use CJ1W-CIF11 with NS. Try to use NS-AL002 if the RS485 network distance is grater than 50m. Regards!