NT Touch switch

[NOOBIE SvS 0]

Hello everbody, I've created a program on a NT30 and connected it with a CPM1A. I made some touchswitches to control the PLC, but it doesn't work with the program. It does control outputs directly not the program.

[NOOBIE SvS 0]

I think the PLC isn't going in RUN mode. How do I get the PLC in RUN mode without a PRO. (PC or NT?).

[nguyenthanhcanh 3]

It's belongs to Startup mode: set it to RUN or Monitor and transfer to PLC (notice: when transer PLC must in program mode), turm power off and then turn on again, PLC will RUN at startup.