Sign in to follow this  
Followers 0
evgeny

Nt-panel + Drive

4 posts in this topic

Here are two questions that I have. Any help is welcomed While changing frequency from touch panel NT31C-V2 ,I can't get the same numbers on the screen Thunbwheel Switch and on the screen Drive( Yaskawa). I am not friendly enough with date conversion.I used"SCL (66)" too. This didn't help.The difference between Thunbwheel Switch and Drive is considerable and it changes not linearly. If it's possible to make the bit 0.00/0.01 be in the mode "on" till the touch "switch up/down" is pressed? If Yes, then how? Edited by evgeny

Share this post


Link to post
Share on other sites
I failed to send file 0000.cxp Edited by evgeny

Share this post


Link to post
Share on other sites
The logic from the touchscreen to the PLC is only positive logic. If you want to invert the logic, you must do it in ladder logic. 0000.00 |--------|\|---------------[iNC]

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0