Sign in to follow this  
Followers 0
Guest bigdog

Barcode Scanner

2 posts in this topic

Does anyone have any advice as to how to connect a Sick CLV410 barcode scanner to the serial port of a Cqm1 plc and display the barcode that is scanned on a nt20. Can figure out how to trigger the scanner, set up display to go into teach mode etc. using plc outputs and inputs to determine if barcode matched or not. But, am at a dead end trying to figure out how to display what is scanned. Cqm1 manual gives some sample codes etc., but try as I might, seems very confusion. Would anyone have a sample piece of code thanks

Share this post


Link to post
Share on other sites
CLV410 Sick ? if it is don't even think trig it by RS232C or any fieldbus. Use PLC-digital output and Relay or opto-coupler for trig. Use RS232C only for reading from the Scanner.. http://www.alanen.info

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0