BobB

How to use alarm buzzer in NS screens

8 posts in this topic

I wish to use the alarm buzzer in an NS screen. I have not been able to find how to do what I want to do. There are about 200 alarms programmed into the screen from a PLC but I only require to use the buzzer for about 8 of them. The buzzer would also need to be muted. Any help appreciated.

Share this post


Link to post
Share on other sites

Hi Bob,

check out the System Bit area SB12/13/15

you can map it to plc area & then drive directly from your program.

 

System Setting/Initial tab. There is a button called System Memory List that gives the allocations 

Share this post


Link to post
Share on other sites

Thank you - will give it a go.

Share this post


Link to post
Share on other sites

Hi proud Kiwi I bet after the test result today LOL. Will not let me allocate SB13 or map to a PLC bit - HELP!!!!

Share this post


Link to post
Share on other sites
44 minutes ago, BobB said:

Hi proud Kiwi I bet after the test result today LOL. Will not let me allocate SB13 or map to a PLC bit - HELP!!!!

i have sent you a PM, can you email me?

 

Share this post


Link to post
Share on other sites

Nothing in my mail box.

Share this post


Link to post
Share on other sites

 

7 hours ago, BobB said:

Nothing in my mail box.

Hmm, maybe I forgot to send. Have just done again now

I thought I would make the attempt at uploading files, but forum failed on me

 

Share this post


Link to post
Share on other sites

System Settings > Initial

Set your system memory base address. ($B0)

On same page click system memory list

First page listed tick the Basics Tab.

Bit 13 and 14 of first word will be your buzzer

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now