How to use alarm buzzer in NS screens

[BobB 56]

I wish to use the alarm buzzer in an NS screen. I have not been able to find how to do what I want to do. There are about 200 alarms programmed into the screen from a PLC but I only require to use the buzzer for about 8 of them. The buzzer would also need to be muted. Any help appreciated.

[lostcontrol 21]

Hi Bob,

check out the System Bit area SB12/13/15

you can map it to plc area & then drive directly from your program.

 

System Setting/Initial tab. There is a button called System Memory List that gives the allocations 

[BobB 56]

Thank you - will give it a go.

[BobB 56]

Hi proud Kiwi I bet after the test result today LOL. Will not let me allocate SB13 or map to a PLC bit - HELP!!!!

[lostcontrol 21]

44 minutes ago, BobB said:

Hi proud Kiwi I bet after the test result today LOL. Will not let me allocate SB13 or map to a PLC bit - HELP!!!!

i have sent you a PM, can you email me?

 

[BobB 56]

Nothing in my mail box.

[lostcontrol 21]

 

7 hours ago, BobB said:

Nothing in my mail box.

Hmm, maybe I forgot to send. Have just done again now

I thought I would make the attempt at uploading files, but forum failed on me

 

[chelton 42]

System Settings > Initial

Set your system memory base address. ($B0)

On same page click system memory list

First page listed tick the Basics Tab.

Bit 13 and 14 of first word will be your buzzer