Posted 10 Jan 2023 Hi, is there a way to upload the safety program that is in the PLC, so i can get a complete project? Share this post Link to post Share on other sites
Posted 10 Jan 2023 For NX/NJ the safety program will upload when you upload from the controller ( assuming the source is transferred). For G9SP you can go online and upload the project. Share this post Link to post Share on other sites
Posted 11 Jan 2023 22 hours ago, photovoltaic said: For NX/NJ the safety program will upload when you upload from the controller ( assuming the source is transferred). For G9SP you can go online and upload the project. Does the OP know to uncheck the transfer slave terminal operation settings box during synchronization? I recall not getting the safety PLC program/settings if I don't uncheck this. Share this post Link to post Share on other sites
Posted 11 Jan 2023 2 hours ago, kckku said: Does the OP know to uncheck the transfer slave terminal operation settings box during synchronization? I recall not getting the safety PLC program/settings if I don't uncheck this. If you connect to a PLC and transfer from the startup screen it will transfer the Safety PLC side as well. I suppose if you are making a project then synchronizing then yes you would uncheck that option - good point. 1 person likes this Share this post Link to post Share on other sites