Posted 5 Dec 2022 First of all, I'm running version 20.01.00 CCW. I have a project that uses a mciro870 and panelview 800. It also has 11 powerflex 525 VFD's attached, all ethernet. Everything has been going well but today I hit a wall when importing tags into the Panelview device group. I currently have a little over 800 tags and will have about 1400 I think when finished. The Plc section shows tons of memory available and when I check through 'config' on the Pv800 itself, it also has tons of memory left. When I do the import, it brings in 744 tags and then skips the remaining one. It even includes that in the msg block after the import. It has to see that tags or it wouldn't know that they are being skipped. I've been trying to work with Rockwell support ( of course I got the new guy who's never seen the software before) and my local distributor. I've looked through the rockwell knowledge base, the manuals and online and I haven't seen this problem posted. Does anyone know if there is a limitation on the number of tags? I can't image an odd number like 744. thanks, mark Share this post Link to post Share on other sites
Posted 5 Dec 2022 Firmware 5.011 has a limit of 400 tags per this manual - https://literature.rockwellautomation.com/idc/groups/literature/documents/rn/2711r-rn001_-en-p.pdf Not sure what number that would be for your firmware level. And thats Panelview Firmware not CCW. 1 person likes this Share this post Link to post Share on other sites