Posted 8 Nov 2022 (edited) I have a VACON X4 drive I want a digital input to Accelerate the motor up to Speed (43Hz) then stay at speed for 25 minutes, and then Decelerate back to 0 speed. On the Woods WFC drive I used C1- Cntl1 01000111and E1-Ecnt1 of 1500sec Do I change Param 405? Edited 8 Nov 2022 by gbradley Share this post Link to post Share on other sites
Posted 11 Nov 2022 I called Danfoss Technical support I found out that not only are the Woods Drive WFC obsolete, but that the Vacon X4 are in the Inactive phase and at End of life as well.Anyway he suggested 491 Seq ApplI will have to read up a little, but I believe that this will get me to where I want to go. Share this post Link to post Share on other sites