Sign in to follow this  
Followers 0
David_29847

1769-L30ER losing network settings

3 posts in this topic

Good morning.

I have an issue that I have never encountered before and am uncertain of where to start. I have three machines, all with 1769-L30ER controllers, and all three of them lost their network settings (see attached screen shot). It happened once before on one of these machines, which was either at the beginning of the year or the end of last year, but hasn't happened since then until now. I have not had this problem any where else in the facility and there are numerous other machines with the same controller.
All three of these are connected to the plant network via the same IDF, just in case that means anything. I am not sure what other information I should provide but I will offer any that I can. TIA!!!

 

NVH_Trim_Press_3.jpg

Share this post


Link to post
Share on other sites

Some questions to help narrow this down.

What Firmware Revision ?

Are you losing just the IP Address or the entire PLC Program?

Is the PLC in RUN or REM mode?

Share this post


Link to post
Share on other sites

**snort** (today is 2022-11-15).

Untitled.png

Edited by drbitboy

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0