1747-L30B Brick SLC "Insufficient Memory Module Size"

[abend 0]

I have a 1747-L30B SLC Brick and it is set to load from EEPROM on boot S:5/8, Error S:1/10, and Run S:1/12. I need to make changes to the program and then store it to EEPROM via "Comms>EEPROM>Store to EEPROM."  When I attempt to store the program with changes, it displays the message "Insufficient Memory Module Size." I assumed the EEPROM memory was maxed out, but I also uploaded the existing program currently stored to EEPROM, made no changes, and attempted storing it back to EEPROM and received the same message. Any advice?

[pturmel 159]

Maybe the error is bogus, but something else.  Is there a read-only or read-write physical jumper?

[abend 0]

If there is a jumper, I haven't located it. I looked over the 1747-L30 Installation and Operation Manual and did not see any reference to a jumper for read-write functions.

[BobLfoot 301]

Have you checked into this technote?

https://rockwellautomation.custhelp.com/app/answers/answer_view/a_id/15983/loc/en_US

Firmware Versions and EEPROM Versions seem to be tricky.

Some eeproms will read to load but not store.