CP1L-EL TCP socket Services

[PrecisionPLC 0]

Hi all

Im having a issue where i have opened a socket to connect with a igus dryve. I can see the socket open in tag A567. 15 and can send a read telegram and get my data back successfully.. The issue im having is that it always closes the socket after a send/receive.. (triggered simultaneously) i really need this socket to stay open until i physically request it to close.. 

I will be using all 3 sockets available for 3 differnt dryves.. 

Any help would be much appreciated.. 

[photovoltaic 120]

You send a send a read and write at the same time?

[PrecisionPLC 0]

No i send a read or a write telegram with data in D00000 then i trigger a receive to get my answer back from the device for what im sending.. Its after this that the sockets close its self.. When i open socket A567. 15 is high the low after a send /receive

[photovoltaic 120]

Can you share your program?

[PrecisionPLC 0]

Program attached 

Filament Sticher_27_09_2022.cxp

[PrecisionPLC 0]

@photovoltaicdid you get a chance to have a look at the program

[photovoltaic 120]

8 hours ago, PrecisionPLC said:

@photovoltaicdid you get a chance to have a look at the program

Probably won't till next week unfortunately. What is the model of drive?

[lostcontrol 23]

Is your intent to control these drives or just monitor?

IMHO, I don’t believe the CP series were designed with this intent (although I could be wrong..)

Even monitoring more than 1x device is pushing the boundaries (I think)