Sign in to follow this  
Followers 0
d4rkm4n

Keypad not showing in simulation

2 posts in this topic

Hi guys.

Somehow I cannot open keypad for numerical input from simulation.

The HMI is using user-defined keywindow for keypad.

Setting as below:

keywindow1.PNG.625edcb277df901260ac68d7b

keywindow2.PNG.4e02fa0aeb11c783bcfbb864c

Any advice on what to check? I have been messing around with the setting with no luck.

Thanks!

Share this post


Link to post
Share on other sites

Found the solution for this.

Check for trigger device.in numerical input setting.

Make sure the device is ON and you good to go.

Normally this was setup due to make sure only one HMI can operate the SP. There are 2 HMI for this system located at different places.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0