MAC address of HMI

[tranthanhtung 0]

Hello everyone,

I would like check MAC address of GT25/GT27 model,

But, I haven't found special address (GS) that storage it.

who have any information about it, could you share for us?

Thanks and best regards!

 

[Gambit 326]

[tranthanhtung 0]

thanks so much Mr.Gambit

However, MAC address have 12 characters ~ 6 Words

Beside, I checked GS408 don't have value (=0)

 

Edited 26 May 2022 by tranthanhtung

[VeeB 8]

Hi tranthanhtung,

You will only specify a start adress (location) where the mac adress will be shown.
If you specify for example write GD150 into GS408. GD150, GD151 and GD152 will contain the mac adress information as shown in the screen capture above.

The MAC adress will be shown in Hex I believe and will fit the 3 registers.

 

[tranthanhtung 0]

On 5/30/2022 at 6:41 PM, VeeB said:

Hi tranthanhtung,

You will only specify a start adress (location) where the mac adress will be shown.
If you specify for example write GD150 into GS408. GD150, GD151 and GD152 will contain the mac adress information as shown in the screen capture above.

The MAC adress will be shown in Hex I believe and will fit the 3 registers.

 

Thanks all for your recommend,

I got it.