tranthanhtung

MAC address of HMI

5 posts in this topic

Hello everyone,

I would like check MAC address of GT25/GT27 model,

But, I haven't found special address (GS) that storage it.

who have any information about it, could you share for us?

Thanks and best regards!

 

Share this post


Link to post
Share on other sites

Screenshot 2022-05-25 130443.jpg

Share this post


Link to post
Share on other sites

Posted (edited)

thanks so much Mr.Gambit

However, MAC address have 12 characters ~ 6 Words

Beside, I checked GS408 don't have value (=0)

 

Edited by tranthanhtung

Share this post


Link to post
Share on other sites

Hi tranthanhtung,

You will only specify a start adress (location) where the mac adress will be shown.
If you specify for example write GD150 into GS408. GD150, GD151 and GD152 will contain the mac adress information as shown in the screen capture above.

The MAC adress will be shown in Hex I believe and will fit the 3 registers.

 

Share this post


Link to post
Share on other sites
On 5/30/2022 at 6:41 PM, VeeB said:

Hi tranthanhtung,

You will only specify a start adress (location) where the mac adress will be shown.
If you specify for example write GD150 into GS408. GD150, GD151 and GD152 will contain the mac adress information as shown in the screen capture above.

The MAC adress will be shown in Hex I believe and will fit the 3 registers.

 

Thanks all for your recommend,

I got it.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now