Sign in to follow this  
Followers 0
vipin

Omron Plc and Two stepper motors

3 posts in this topic

Posted (edited)

Hello everyone I'm new to omron plc . I have a system which consists 

1. Omron Plc CP2E

2. Two stepper motors and their drivers. 

3. 4 Inputs-  one stepper start push button, second stepper go back push button, third stepper 1 home sensor, fourth stepper 2 home sensor

4. 4 Outputs- stepper 1 step(-) Q 100.00, stepper 1 dir(-) Q100. 02, stepper 2 step(-) Q100. 01, stepper 2 dir(-) Q100. 03

Seuence is like that:-

Initially both stepper motors are at their home sensor. 

When start push button is pressed both stepper move 110 mm distance and then stop. 

Now when go back push button is pressed both stepper motors should go back to their home sensors and should stop at reaching their hone sensors. 

This is the sequence. Can someone please send me the program by writing in cx - programmer or upload the photos of ladder program and settings also. Please

IMG_20220411_125234.jpg

Edited by vipin

Share this post


Link to post
Share on other sites

hyee... do you already solve the problem 

I kind of have same problem with U but i using omron cp1e 

if u already solve it ... can U show me ur ladder diagram and ur wiring ??

Share this post


Link to post
Share on other sites

Posted (edited)

No.. I didn't get the solution. If I get the solution I will post it here. And you can post if you get the solution before I get it. 

Edited by vipin

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
Sign in to follow this  
Followers 0