kdshaw87

Connect FX3G-40M to proface HMI GP-4301TM

3 posts in this topic

Good Morning,

 

We are in need of a solution to connect the pro-face HMI GP4301TM to a FX3G-40M mitsubishi plc. Every time we connect the cable to the front port on the PLC (the 9 pin circular port) the HMI mentions that the cable is disconnected or the PLC is off. We currently are trying to connect WITHOUT the FX-232, FX-485, or FX-422. It seems if this is done terminal coupling resistances need to be installed. 

Is the above (without any input modules) doable to the listed HMI? If so what is the preferred communication protocol, the correct port (Com 0, 1, or 2) and the correct wiring from the 9 Pin db9 connector port on the front of the FX3G-40M. 

 

Thank you!

attatched are the photos of my current settings on both PLC and HMI

PLC settings.PNG

Pro-face Settings.PNG

Share this post


Link to post
Share on other sites

Hi kdshaw87,

The PLC 8-pin front port (MiniDIN 8) is RS-422 (4-wire), not RS-232. Appearently your HMI is set for RS-232, what seems incorrect.

Another important point is the protocol. Does Proface driver for Mitsubishi mentions which protocol it does use? The PLC front port only accepts programming protocol, not MC Protocol in any format.

The front port is "CH0" so, the serial port parameters you sent does not apply to front port, only to extension ports, what is not your case.

Regards!

1 person likes this

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now