Stefano A.

CP2E and Analog In/Out (CP1W-MAB221) setup in CX-programmer "settings"

3 posts in this topic

Hi, 
I have a CP2E PLC (CP2E-N30DRD) with an Analog In/Out board CP1W-MAB221.
I can't find a method to setup it correctly (the ERR LED is fixed in ON state).

The "W516 (Section10) CP1L-EL_EM ANALOG OPTION Boards" manual
says to "set the baud rate of the relative option port at 115200bps in Toolbus
mode.", however in CX-Programmer , under "Settings" and "Serial 1" tab there is not
such protocol.

In w614 (cp2e software manual) and w613 (cp2e hardware manual) I haven't found any other tips.

Can you help me please?
Thank you.
Serial1settings.png.466776c59b027d5d0d4b

Share this post


Link to post
Share on other sites

Page 17-5 of W614 shows the port should be set for baud 115200 format 7,2,e mode host-link. See attached.aaa.thumb.png.2714776e29c3865acd84a6476b

2 people like this

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now