Sergei Troizky

Cannot attach element comments

8 posts in this topic

Posted (edited)

Two projects. The same PC. Both projects created and edited on this PC, using the same version of Sysmac Studio.
Able to attach element comments in one project and unable to attach to any element in another (the option is greyed out in the right-click menu).
Element comments are enabled in the Sysmac Studio Option menu in both cases.

Any ideas?

Edited by Sergei Troizky

Share this post


Link to post
Share on other sites

Is this a factor in your project?

Mr_PLC_ElementComments.thumb.JPG.d058e24

Share this post


Link to post
Share on other sites

Posted (edited)

As I said earlier, there is no difference in the PLC model (NX102 v1.41), Sysmac Studio version (also v1.41) and both projects are on the same PC.
One project allows creating element comments, while another does not.

Edited by Sergei Troizky

Share this post


Link to post
Share on other sites
On 10/4/2021 at 9:16 AM, Sergei Troizky said:

As I said earlier, there is no difference in the PLC model (NX102 v1.41), Sysmac Studio version (also v1.41) and both projects are on the same PC.
One project allows creating element comments, while another does not.

You never mentioned PLC or version.  The only reason I know that they would not show is the one brought up by IO_Rack, are you certain both projects have the correct firmware version selected?  Firmware is always backward compatible, so maybe 1.41 wasn't selected in one project.

Share this post


Link to post
Share on other sites

Can you clarify, please, firmware version of what and where in the project?

Share this post


Link to post
Share on other sites

Right click on the PLC and choose Change Device.

Mr_PLC_ChangeDevice.JPG.a11c37664a5a1cc1

Share this post


Link to post
Share on other sites

Thanks, this helped.
It was set to 1.30 in the project. Another one is set 1.31.

Share this post


Link to post
Share on other sites

The PLCs are always backward compatible, but to get all the latest features, this should be set to match the version listed on the side of the PLC.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now