Hex Conversion

[cartduty 0]

Hello everyone, I am working with a mitsubishi fx-2n. I need to convert the decimal data in a Dw to a hex equivelant. I could not find any instruction to do this. Does anyone know if one exist? Thanks!!

[mjrx 1]

You can view the data value in monitor mode as hex or decimal constant. Go to Online->Monitor->Change Current Value Hexadecimal. If data is going to an HMI, most HMI's allow display format in Int or Hex. Constants can be prefixed with an H (instead of K) for hex constants. I am not sure if this is what you are looking for.

[cartduty 0]

Yes you were right. I was reading a DW to a HMI. I didn't even think to check the format in the HMI! DUH! Thanks Again!

[Guest Brandon]

You also can always go to the windows calculator and change it over to the scintific mode. You can then put a decimal value in and covert it to hex. Just an easy tool everyone has.